socomec COUNTIS M43 - 3.3.8 CT Setting

- 17
-
2
Press to enter the selection
routine. The current setting will flash.
Use and
buttons to choose Stop Bit (2 or 1)
Note: Default is 1, and only when the parity is NONE that the stop bit can be changed to 2.
3.3.8 CT Setting
The CT option sets the secondary current (CT2 1A or 5A) of the current transformer (CT) that wires to the
meter.
1
From the Set-up menu, use
and buttons to select the CT
option.
2 Secondary CT setting
Press to enter the CT
secondary current selection
routine.:5A/1A
3
Set CT Ratio value Press to
enter the CT Ratio setting screen. Use
and buttons to
choose the CT ratio. The range is from
0001 to 9999.