socomec DIRIS Digiware C-31 - Configuration; Configuration Using Easy Config; Connection Modes

40 EN
DIRIS DIGIWARE DC - 545830B - SOCOMEC
10. CONFIGURATION
Conguration can be carried out via the Easy Cong conguration software or directly from the DIRIS Digiware D
remote display. The Easy Cong software allows DIRIS Digiware to be congured directly via RS485 or USB. Easy
Cong must be installed before using the USB connection.
If DIRIS Digiware is combined with the G-30, G-40, G-50 or G-60 gateway, it can be congured via this and the
Ethernet port or USB.
To set the parameters from the DIRIS Digiware D remote display, refer to the manual for the display.
10.1. Conguration using Easy Cong
10.1.1. Connection modes
Conguration using Easy Cong directly (USB)
DIRIS Digiware I
DIRIS Digiware U
USB cable for
conguration:
ref.48290050
Easy
Cong
PC
USB
Conguration using Easy Cong via a DIRIS G gateway (USB)
RS485 RS485 RS485
DIRIS Digiware C-31
DIRIS G
DIRIS
COUNTIS
RS485
DIRIS B-30
Easy
Cong
PC
USB
Digiware Bus
Conguration using Easy Cong via a DIRIS Digiware D monitor (USB)
Easy
Cong
PC
USB
DIRIS Digiware D-40 / D-50 / D-70
RS485
RS485
DIRIS B-30
DIRIS
COUNTIS
Digiware Bus