socomec DIRIS Digiware D-70 - Calibrating the Current Sensors; Connection to the Electrical Network and to the Loads

27EN
DIRIS DIGIWARE DC - 545830B - SOCOMEC
6.4.2. Calibrating the current sensors
Current sensors must be calibrated without load.
Calibration must always be carried out with the sensors connected to the DigiwareI-3xdc without load owing
through the sensors.
There are three ways to perform this calibration:
Press
10 sec.
Press and hold (> 10 seconds) the
button of the DIRISDigiwareI-3xdc
The ON LED blinks rapidly during 10
sec to indicate that calibration was
successful.
Current sensors can also be calibrated using the Easy Cong conguration software or a DIRIS Digiware D screen.
6.5. Connection to the electrical network and to the loads
Each DIRIS Digiware I current measurement module can measure several loads simultaneously. This approach
allows great exibility in terms of where it is tted in the installation.
The loads are measured using several types of current sensor (solid-core or split-core) for new or existing
installation. The link between each DIRIS Digiware I current measurement module and its connected sensors is
made using specic cables. This connector allows rapid assembly without tools, without risk of wiring error.