socomec DIRIS Digiware D-70 - Using Easy Config

41EN
DIRIS DIGIWARE DC - 545830B - SOCOMEC
Conguration using Easy Cong via a DIRIS G gateway (Ethernet)
RS485 RS485 RS485
DIRIS Digiware C-31
DIRIS G
DIRIS
COUNTIS
RS485
DIRIS B-30
Ethernet
Easy
Cong
PC
Digiware Bus
Conguration using Easy Cong via a D-50 DIRIS monitor (Ethernet)
Digiware Bus
Ethernet
Easy
Cong
PC
DIRIS Digiware D-50 / D-70
RS485
RS485
DIRIS B-30
DIRIS
COUNTIS
These products must be connected to the power supply before you congure them.
For the Digiware bus and 120-ohm termination resistors, see section “Communication”, page 37.
10.1.2. Using Easy Cong
Easy Cong is conguration software used to set product parameters easily and quickly. Parameters are set in
successive steps:
Network —> Loads —> Measurement method —> Values to be stored —> Alarms —> End of conguration