socomec Green Power 2.0 - INSTALLATION OF MODBUS TCP CARD; COM-SLOTS LOCALISATION; UPS COM2 MODBUS SERIAL LINK DEFAULT SETTINGS

6. 1. ‘com-sLots’ LocaLisation
The « Com-Slots » integrates all communication interfaces and it is located on the right side.
Please, see on the manual of the concerned UPS to see the correct localisation of the «com slot 2»
6. 2. UPs com2 modbUs sEriaL Link dEfaULt sEttings
Baud rate: 9600 bauds
Parity: NONE
Data: 8 bits
Stop: 1 bit
Slave: 1
The serial link settings can be set from the control panel.
These settings are compulsory to make the Modbus TCP communication available
6. INSTALLATION OF MODBUS TCP CARD
1
2
9
Delphys green power - Ref.:
IOMDGPJB0910-GB_11
ENGLISH