ITYS 6-10 kVA - 551431A - SOCOMEC
29
EN
5. INSTALLATION
It is recommended to move the equipment to the installation site by using a pallet
jack or a truck before unpacking.
The system may be installed only by qualied electricians in accordance with
applicable safety regulations.
The cabinet is heavy, please install it with at least two peoples.
5.1. Inspecting the equipment
If any part of the equipment has been damaged during shipment, keep the
shipping cartons and packing materials for the carrier or place of purchase
and le a claim for shipping damage.
5.2. Unpacking the unit
Unpacking the unit in a low-temperature environment may cause
condensation occurred in and on the cabinet. Do not install the unit until the
inside and outside of the unit are absolutely dry (hazard of electric shock).
Remove the packing materials and lift the unit out with two people at least.
Note: The cabinet is heavy, please see spec weight provided on the
carton/label.
Do not lift the unit by its front panel and rear panel.
Discard or recycle the packaging in a responsible manner, or store it for
future use.
Packing materials must be disposed in compliance with all local
regulations concerning waste. Recycling symbols are printed on the
packing materials to facilitate sorting.
To Next Page
Loading...
