17GB
SNMP CARD II - SOCOMEC
3.3. ATS Management
This section contains the control parameters of the STATYS XS connected to the SNMP CARD.
ATS C
ONTROL
This page allows user to turn on or off the Buzzer control and manually transfer source by click-
ing on the [Switch] button as shown below. (Figure 3-7)
Figure 3-7 SNMP CARD ATS Control screen
EMD C
ONFIGURATION
This EMD confi guration allows user to confi gure the EMD parameters as shown below (Figure
3-8). Set the EMD status to Auto allows auto detection of EMD type. For more information about
EMD device setup, please see the EMD_ installation_ manual.
Figure 3-8 EMD Confi guration screen
To Next Page
Loading...