22 GB
SNMP CARD II - SOCOMEC
S NMP TRAP RECEIVERS
This table can hold a maximum of four entries. It holds the list of the IP address of the Network
Management Stations (NMS), which will receive the SNMP traps send by SNMP CARD. (Figure
3-15)
1. Index: The index number of the entry in the table.
2. NMS IP Address: The IP Address in dotted format of the NMS station to which the trap
should be sent.
3. Community String: Low-level password associated with the IP Address. The maximum
length of the string is 16 characters.
4. Trap Type: Types of traps to be received.
• None: Traps will not be received
• SNMP CARD Trap: Traps are received based on Standard STATYS XS MIB.
5. Severity: Set the level of the trap to be received.
• Information: All traps are received
• Warning: Receive trap that has warning and alarm status.
• Severe: The signifi cant traps are received
6. Select Events: Press the “select” button; you can see an event list. You can tick the events
that you would like to receive the notifi cation by trap when the event occurs.
7. Description: Customer description string.
Note: For specifi c application can be found in Chapter IV of the "Simple Network Management
Protocol" Management SNMP CARD / STATYS XS content.
Figure 3-15 SNMP TRAP Receivers
To Next Page
Loading...