30 GB
SNMP CARD II - SOCOMEC
4. MANAGING SNMP CARD /STATYS XS VIA SNMP
4.1. Setting SNMP parameters in SNMP CARD
Before using SNMP CARD in SNMP environment, the IP address, gateway must be confi gured
properly. See Chapter 2 for details.
4.2. S NMP Access Control Setting
SNMP CARD supports SNMP protocol. You can use SNMP NMS to manage STATYS XS
through the network. The IP address of the workstation must be entered in the SNMP CARD
write access table to prevent unauthorized users from confi guring SNMP CARD via HTTP or
SNMP protocols.
Note: If you do not enter the IP address of the workstation to the Access Control Table (via Serial
Port or Telnet) or the SNMP/HTTP Access Control (via Web Browser) in SNMP CARD, the SNMP
NMS can only view the STATYS XS status; it will not be able to perform any confi guration on
SNMP CARD/STATYS XS. (See Pg.22 SNMP/HTTP Access Control)
4.3. S NMP Trap Receivers Setting
See Pg. 22 SNMP Trap Receivers for details.
4.4. Set up SNMP Manager Software
1. Add the MIB fi le of SNMP CARD in the SNMP CARD CD-ROM to the MIB database of the
SNMP manager.
2. Search for SNMP CARD in the network
3. To access the SNMP CARD SNMP agent, use ‘public’ for the GET community string and the
Read/Write password (default is admin) for the SET community string.
GET Community string: public
SET Community string: admin
For more information, see the MIB fi le on the SNMP CARD CD-ROM.
To Next Page
Loading...