34 GB
SNMP CARD II - SOCOMEC
6. APPENDIX B FIRMWARE UPGRADES
6.1. General information
To perform fi rmware upgrading, SNMP CARD must be connected to the same network as the
workstation from which the fi le is to be sent.
In the SNMP CARD Control menu, check that the Network Upgrade is enabled and you have
the login string information and the Community Read/Write Password.
6.2. Updating SNMP CARD Firmware from Windows
To perform fi rmware upgrade, use the upgradeVX.00.exe program on the SNMP CARD CD-
ROM. This program is compatible with Windows.
1. Device List: Displays the addresses of the SNMP CARD present in the local network.
2. Discover: Search for the SNMP CARD on the local network.
3. Remove: Removes the selected SNMP CARD from the STATYS XS List.
4. Modify: Modify the parameters of the selected SNMP CARD in the STATYS XS List.
5. Add: Add the IP address of a SNMP CARD to the STATYS XS List manually.
6. Browse: Open SNMP CARD Webpage of the SNMP CARD from the STATYS XS List.
7. Set IP: Re-set SNMP CARD IP Address; Subnet Mask and Gateway Address in the STATYS
XS List.
8. Upgrade: Upgrade the selected SNMP card in the STATYS XS List.
9. Open: Open and load the new image fi le for upgrade.
10. Quit: Exit the program.
Note: You can simultaneously upgrade up to 4 SNMP CARDs on the network using the up-
gradeVX.00.exe program
To Next Page
Loading...