Soekris Engineering ApS dac1541 Users Manual
www.soekris.dk 7 July 2017
dac1541 rear view
Analog Out: The dac1541 have balanced line out using 3 pins XLR sockets, marked “R” for the
right channel and “L” for the left channel. It also have single ended line out using RCA sockets, the
red one marked “R” is for the right channel, the white one marked “L” is for the left channel.
Digital In: The dac1541 have a total of 5 digital inputs.
“TOS”: SPDIF Optical Toslink.
“RCA”: SPDIF 75 ohms Coax, transformer isolated.
“BNC”: SPDIF 75 ohms Coax, transformer isolated.
“AES”: SPDIF 110 ohms balanced AES/EBU, transformer isolated.
“USB”: USB type B socket: For connection to the USB interface on your computer or other audio
source device. You need to use a high quality USB cable, like the USB cable included with the
dac1541. The switch next to the USB socket is used to select between USB Audio Mode 1, which
can be used without drivers on Windows operating systems, and USB Audio Mode 2, which
require drivers for Windows operating systems.
Windows Drivers: Drivers for using USB Audio Mode 2 on Windows operating systems are
available for downloading on http://www.soekris.dk/download.html. Please note that most newer
versions of Apple OS X or Linux don’t require drivers but will support USB Audio Mode 2
directly, see manual for your operating systems as needed.
Power Socket: The dac1541 support power input voltage from 90V to 264V AC using a IEC14
socket with protective ground, which should enable it to work worldwide directly. The power
socket has a built-in fuse holder. If the fuse ever become defect please replace it with a 5x20 mm
1AT fuse rated for 250V use.
Power Cable: The dac1541 is supplied without a power cable, but any power cable designed to fit
between an IEC14 socket and the wall power socket in your country can be used, it don’t need to be
anything fancy.
To Next Page
Loading...