SOFAR 1.1K~3.3KTL-G3 User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd
Step 3 Connect AC output cable as per the following requirements:
Connect the yellow-green wire to the hole labeled "PE", fasten the wire using an Cross
screwdriver;
Connect the brown wire to the hole labeled "L", fasten the wire using an Cross
screwdriver;
Connect the blue wire to the hole labeled "N", fasten the wire using an Cross screwdriver.
Figure 4-20
L--Brown, N--Blue, PE--Yellow-green
Step 4 Insert the AC connector and hear
"click", then tighten the waterproof nut at
the instantaneous value, as shown in the
figure below, to ensure that the cable is
firmly connected.
Figure 4-21
Step 5 Connect the connected AC
connector to the AC connector of the
inverter. Turn the ac connector knob to lock
until you hear a "click" and the clasp is in
place.
Figure 4-22
To Next Page
Loading...
