Sofar solar 1.1K-3.3KTL-G3 - Page 56

SOFAR 1.1K~3.3KTL-G3 User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd
- 51 -
Event List is used to display the real-time event records, including the total
number of events and each specific ID No. and happening time. User can enter
Event List interface through main interface to check details of real-time event
records, Event will be listed by the happening time, and recent events will be listed
in the front. Please refer to below picture. Long press the button and short press the
button to turn the page in standard interface, then enter into “2.Event List”
interface.
2. Event List
1. Current event
2. History event
Fault information
001 ID04 06150825
( Display the event sequence number, event ID
number, and event occurrence time )
(C) “SystemInfo” Interface as below
3.SystemInfo
------Long press the button
1.Inverter Type
8.Power Factor
2.Serial Number
9.Reflux Power
3.Soft Version
10.Safety Paras
4.Hard Version
11.MPPT Scan
5.Country
12.Power Ratio
6.Modbus Address
7.Input Mode
The user enters the main menu by long pressing the button, short press and
turns the page to select menu contents, then long press the button to enter "3.
SystemInfo". Turning the page down can select the system information to view.
(D) Display Time
Long press the button and short press the button to turn the page in the
standard user interface to enter into “4.Display Time”,then long press the button to
display the current system time.
(E) Software Update
User can update software by USB flash drive , Sofarsolar will provide the new