Sofar solar 3.3-12KTL-X - Installing the SOFAR 3.3 K~12 KTL-X; Figure 3-2 Wall Clearances for Single Inverter; Figure 3-3 Wall Clearances for Multiple Inverters

SOFAR 3.3K~12KTL-X User manual
All rights reserved
© Shenzhen SOFARSOLAR Co ., Ltd.
22
Figure 3-2 Wall clearances for single inverter
3.5. Installing the SOFAR 3.3K~12KTL-X
Step 1 To determine the position for drilling holes, level hole positions, and
then mark the hole position by using a marker, use the hammer drill to drill
hole on the wall. Keeping the hammer perpendicular to the wall, do not shake
when drilling, so as not to damage the walls. If the aperture errors, need to
reposition.
Step 2 The expansion screw is vertically inserted into the hole, pay attention
to expanding screw insertion depth (not too shallow).
Step 3 Putting the rear panel on the wall, the rear panel is fixed by the nuts.
Step 4 Putting the SOFAR 3.3K~12KTL-X hook on the rear panel.
Figure 3-3 Wall clearances for multiple inverters