ME3000SP User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd
Step 1: Loosen 4 screws (A) using a screwdriver (fig. 6);
Step 2: Remove the waterproof cover (B), loosen the cable gland (C), and then remove the stopper (G);
Step 3: Route the battery wires (F) through the cable gland, then connect battery wires using OT terminal (E);
Step 4: Fasten the waterproof cover using 4 screws.
4.2Inverter logic interface connect
Fig. 7 Inverter logic interface connection
Step 1: Loosen 4 screws (A) using a screwdriver (fig. 7);
Step 2: Remove the waterproof cover (B),Loosen the cable gland (C), and then remove the stopper (G);
Step 3: Press the wire terminals in color sequence;
Step 4: Route Cable terminal through the cable gland, Insert the communication cable into the RJ45
connector;
Step5: Fasten the waterproof cover using 4 screws.
The logic interface pin definitions and circuit connections are as follows:
Logic interface pin are defined according to different standard requirements.
（a）Logic interface for AS/NZS 4777.2:2015, also known as inverter demand response modes (DRMs).
To Next Page
Loading...
