Sofar solar SOFAR 7.5KTLM - Page 31

SOFAR 7.5KTLM User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd
- 26 -
Step 5 Insert crimped power cables into corresponding housings until you hear
a "click" sound. The power cables snap into place.
Step 6 Reinstall cable glands on positive and negative connectors and rotate
them against the insulation covers.
Step 7 Insert the positive and negative connectors into corresponding DC
input terminals of the inverter until you hear a "click" sound, as shown in Figure
4-7.
Figure 4-7 Connecting DC input power cables
1.Bayonet
Note:Insert the stoppers into the unused DC connectors.
Follow-up Procedure
To remove the positive and negative connectors from the inverter, insert a
removal wrench into the bayonet and press the wrench with an appropriate strength,
as shown in Figure 4-8.
Before removing the positive and negative connectors, ensure
that the DC SWITCH is OFF.
Caution
Figure 4-8 Removing a DC input connector