This document describes a body massager, available in models ME7711, ME7712, and ME7713, designed for home use to provide an effective therapeutic massage. The device aims to improve blood circulation, achieve firmer and smoother skin, eliminate fluids and toxins, and reduce accumulated fat and "orange peel" skin. It features a main body with an on/off switch for massage and red LED, a variable massage intensity control, and red LEDs for an additional massage function to strengthen effectiveness.
The massager comes with several interchangeable heads, each designed for specific treatments. These include:
- Finger massage head (PRE-TREATMENT): Used for painful cellulite and aching muscles.
- Serrated roller head (ANTI-CELLULITE): Designed to eliminate cellulite, tighten skin, stimulate blood flow, tone muscles, perform lymphatic drainage, reduce volume, and relieve backache, sciatica, lumbago, and stress.
- Exfoliating head (DRY BRUSH): An exfoliating brush that removes dead skin and stimulates blood flow.
- Wave shaped head (BODY CONTOUR): Tones and improves blood circulation, particularly for thigh and buttock areas.
- Smooth roller head (BODY-MODELLING): Provides effective treatment for painful cellulite.
- Ball massage head: Stimulates and tones muscles, helps firm skin, improves abdominal circulation, eliminates localized toxins, and aids intestinal tract function to prevent constipation.
- Parallel spiky disk massage head (ANTI-CELLULITE): Another head for anti-cellulite treatment.
- Fabric cover: Exclusively for use with the BODY-CONTOUR toning head for greater comfort, especially when not using creams.
Usage Features:
Before use, ensure all packaging is removed and the cable is fully unrolled. The appliance should be connected to the mains, and the on/off switch used to turn it on. The massage intensity can be regulated using the intensity control, starting with a gentle speed and gradually increasing based on sensitivity. The red light function can be activated for enhanced massage effectiveness.
To attach a massage head, align it with the head adaptor and secure it (refer to Fig. 3). The intensity is adjusted by turning the controller (3) with a finger (Fig. 4). The switch (2) can be moved to either the "massage" position (Fig. 2 B) or the "massage + infrared" position (Fig. 2 C) depending on the desired treatment.
When using the massager, hold it firmly with both hands and move it over the skin in the direction of blood circulation. It should be glided gently without pressing too hard, as excessive pressure can prevent the motor from operating efficiently.
Massage Direction Guidelines:
- Always glide the appliance upwards, in the direction of blood circulation.
- Legs: Place the appliance on the thigh, close to the knee, and glide gently upwards towards the hip (Fig. 5).
- Buttocks: Use a combination of upward and circular movements (Fig. 6).
- Abdomen: Place the appliance on the navel and move it gently outwards (Fig. 7). Avoid circular movements around the navel.
- Arms: Place the appliance close to the elbow and glide it gently towards the armpit. Repeat the massage from the armpit towards the elbow (Fig. 8).
- Back: Place the appliance in the area of the spine and glide it gently upwards towards the shoulder blade (Fig. 9).
- Never directly massage the spine or bones (knee, ankle, elbow) to avoid injury from protruding parts of the massage head.
Skin Preparation and Treatment Steps:
- Skin Preparation: Begin by exfoliating the skin using the DRY BRUSH head (natural bristle brush) to remove dead cells and soften the skin. Exfoliate gently for 5 minutes, once per week, brushing towards the heart (from feet to hips for legs, and wrist to shoulder for arms). Adjust intensity based on skin condition and sensitivity.
- Warm Up: For effective treatment, pre-warm and drain the area, especially for hard, painful cellulite. This helps to gradually knead the area, making fat easier to separate, shifting retained toxins, and activating local venous and lymphatic circulation. Use very gentle, shallow movements for lymphatic drainage to stimulate the lymphatic system and increase fluid removal.
- Treatment: Once warm-up is complete, use the ANTI-CELLULITE or BODY-MODELLING head. Unlike draining, reduction massage involves strong, fast, repetitive movements on the skin, using kneading and sliding motions. This is recommended for body contouring, targeting "saddlebags," abdomen, and buttocks.
- Completion: Apply a moisturizing or treatment cream using the BODY-CONTOUR head.
After use, stop the appliance by releasing pressure on the on/off button, unplug it from the mains, and clean it.
Safety Advice and Warnings:
- Read instructions carefully before use and keep for future reference.
- The appliance can be used by children aged 8 and above, and persons with reduced physical, sensory, or mental capabilities, or lack of experience, if supervised or instructed on safe use and understanding of hazards.
- Cleaning and user maintenance should not be performed by children unless supervised.
- If the mains connection is damaged, it must be replaced by an authorized Technical Assistance Service. Do not attempt to dismantle or repair it yourself.
- Ensure the voltage on the nameplate matches the mains voltage.
- Connect to an earthed socket (minimum 10 amperes). Do not alter the plug or use adaptors.
- Keep children and bystanders away during use.
- Do not use if the cable or plug is damaged, if any casing breaks, or if it has fallen, shows visible damage, or leaks.
- Do not use with damp hands or feet, or when barefoot.
- Do not force the electrical wire; never use it to lift, carry, or unplug the appliance.
- Do not wrap the cable around the appliance. Check the power cord for damage.
- Do not use or store outdoors.
- Do not touch the plug with wet hands.
- Do not expose to rain or moisture; water ingress increases electric shock risk.
- Keep the appliance dry. Do not use near water, bathtubs, showers, or swimming pools.
- Keep away from heat sources and sharp edges.
- Do not use on the abdomen if pregnant or suspecting pregnancy.
- Consult a doctor if you have health problems (e.g., pacemaker).
- Do not use directly on skin rashes, inflammation, burns, open wounds, infected skin, varicose veins, poor circulation, bruising, vein inflammation, thrombosis, torn skin, or if you have diabetes.
- Do not use if taking medication that reduces sensory capacity.
- Do not use if accessories are not properly fitted or if the on/off switch does not work.
- Disconnect from mains when not in use, before cleaning, making adjustments, or changing accessories.
- For household use only, not professional or industrial.
- Store out of reach of children and those with reduced physical, sensory, or mental abilities, or those unfamiliar with its use.
- Keep in good condition; check that moving parts are not misaligned or locked, and that there are no broken parts or anomalies.
- Never leave connected and unattended when not in use to save energy and prolong life.
- Do not use on pets or animals.
- Do not use for more than 20 minutes at a time; allow to cool for one hour before reuse.
- Do not fall asleep while using the appliance.
Maintenance Features:
- Cleaning: Disconnect the appliance from the mains and let it cool before cleaning. Use a damp cloth with a few drops of washing-up liquid, then dry. Do not use solvents, acid/base products (e.g., bleach), or abrasive products. Do not submerge the appliance in water or any other liquid, or place it under a running tap.
- Anomalies and Repair: If problems arise, take the appliance to an authorized technical support service. Do not attempt to dismantle or repair it yourself, as this can be dangerous.
Ecology and Recyclability:
The packaging materials are part of a collection, classification, and recycling system. Dispose of them in appropriate public containers for each material type. The product does not contain harmful substances. When the product's working life ends, take it to an authorized waste agent for selective collection of waste electrical and electronic equipment (WEEE). This appliance complies with EU Directives on Low Voltage (2014/35/EC), Electromagnetic Compatibility (2014/30/EC), restrictions of hazardous substances (2011/65/EU), and ecodesign requirements for energy-related products (2009/125/EC).
Need help?
General
To Next Page
