EasyManua.ls Logo

Soladey ion5 - Brushing Technique and Tongue Care; Activating Your Soladey J3 X Toothbrush

Default Icon
3 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IONIC TOOTHBRUSH
Soladey International Ltd. All Rights Reserved.
PAGE 2
HOW TO USE
Instructions for best use of your Soladey Ionic Toothbrush
After wetting the bristles and semiconductor with water (saliva is
sufcient outdoors - *see note below) brush all surfaces of your tongue
without using toothpaste, and especially rst thing in the morning after
stomach acids have accumulated from sleeping.
Brush from the back of tongue (not in the throat!) to the tip of the tongue. You may see
discoloration on the bristles (concentrated bacteria and accumulation of acids), and so
make sure you rinse the bristles repeatedly with water to remove this lm. Once you feel
the bristles and tongue are adequately clean then you can work on the tooth surfaces as
there will be less concentration of bacteria in the mouth.
Bear in mind that the tongue generally carries most of the mouths bacteria! Continue to
brush your teeth lightly and thoroughly in the same way as with an ordinary toothbrush.
Concentrate on contacting the teeth rather than applying force. Unlike a conventional
toothbrush, Soladey eliminates the necessity to apply much pressure to the tooth
surface.
*Note: Saliva is sufcient for brushing teeth outdoors, but in this case we dont
recommend you brush your tongue outdoors without a source of running water available
to clean the bristles.
Soladey J3X is a hybrid toothbrush. Light received either/both on the rod
or on the solar panel will activate the ions.
Make certain there is an adequate light source (natural or articial) necessary to activate
the semiconductor and solar panel. If you are brushing the back teeth surfaces the rod
will receive limited direct light, so make sure you do not cover the solar panel with your
hand as the solar panel will transfer the light to the rod even when light conditions are
low. The amount of light required for the J3X to work effectively is the same level that
would be required to power an electronic calculator. Sunlight works well, and also a well-
lit environment is equally as effective.
The brighter the source of light the better the result. You will notice that your saliva will
foam slightly when the toothbrush is working effectively. If you are using toothpaste, use