Solar Light-N-Carry LNC1541

To Next Page

COB LED Rechargeable Work Light

Operator’s Manual

Model Nos. LNC1241, LNC1341, LNC1541

WARNING

Read these instructions completely before using the Jump-N-Carry and save them for

future reference. Before using the Jump-N-Carry to jump start a car, truck, boat or to

power any equipment, read these instructions and the instruction manual/safety

information provided by the car, truck, boat or equipment manufacturer. Following all

manufacturers’ instructions and safety procedures will reduce the risk of accident.

Working around lead-acid batteries may be dangerous. Lead-acid batteries release

explosive gases during normal operation, charging and jump starting. Carefully read and

follow these instructions for safe use. Always follow the specific instructions in this

manual and on the Jump-N-Carry each time you jump start using the Jump-N-Carry.

All lead-acid batteries (car, truck and boat) produce hydrogen gas which may violently

explode in the presence of fire or sparks. Do not smoke, use matches or a cigarette

lighter while near batteries. Do not handle the battery while wearing vinyl clothing

because static electricity sparks are generated when vinyl clothing is rubbed. Review all

cautionary material on the Jump-N-Carry and in the engine compartment.

Always wear eye protection, appropriate protective clothing and other safety equipment

when working near lead-acid batteries. Do not touch eyes while working on or around

lead-acid batteries.

Always store clamps in their holsters, away from each other or common conductors.

Improper storage of clamps may cause the clamps to come in contact with each other,

or a common conductor, causing the battery to short circuit and generate high enough

heat to ignite most materials.

Use extreme care while working within the engine compartment, because moving parts

may cause severe injury. Read and follow all safety instructions published in the vehicle's

Owner's Manual.

While the battery in the Jump-N-Carry is a sealed unit with no free liquid acid, batteries

being jump started with the Jump-N-Carry unit likely contain liquid acids which are

hazardous if spilled.

Failure to follow instructions may

cause damage or explosion,

always shield eyes. Read entire

instruction manual before use.

WARNING

Main Page

Need help?

Do you have a question about the Solar Light-N-Carry LNC1541 and is the answer not in the manual?

Summary

Introduction and Battery Care

Manual Usage and Preservation

Emphasizes saving and reading the manual before each use for safe operation.

Lithium Battery Maintenance

Details the importance of keeping the sealed lithium battery fully charged for optimal life.

Important Safety Instructions

General Safety Directives

Covers critical prohibitions for safe use, including charging, light exposure, and supervision.

Charger Safety Warnings

Specifies that the AC charger is for indoor use only and warns against using other chargers.

Personal Safety and Features

Personal Safety Precautions

Focuses on user safety, including avoiding disassembly, extreme temperatures, and battery disposal.

Work Light Features

Lists key components and functionalities of the work light, such as buttons, light modes, and attachment features.

Charging Instructions

Charging Procedure Steps

Details connecting the microUSB and USB ends of the cable to charge the work light via AC outlet.

Charging Status Indicators

Explains how the blue LEDs indicate charging progress and full charge status.

Operating and Maintenance Instructions

Work Light Operation Modes

Guides users on turning the light on/off and cycling through COB and Focus Beam light modes.

Maintenance and Servicing

Provides instructions for cleaning the unit and specifies that servicing should be done by qualified personnel.

Storage and Replacement Parts

Storage Guidelines

Advises storing the unit in a cool, dry place and maintaining battery charge to prevent self-discharge.

Replacement Parts Information

Lists available replacement parts, such as the charger kit, and provides part numbers for ordering.

The device described in this manual is a COB LED Rechargeable Work Light from the "Light-N-Carry" brand, with model numbers LNC1241, LNC1341, and LNC1541. It is designed to provide portable illumination for various tasks.

Function Description:

This work light serves as a portable, rechargeable lighting solution. It features both a COB (Chip-on-Board) LED for broad area illumination and an SMD (Surface-Mount Device) LED for a focused beam. The unit is powered by a sealed lithium battery, emphasizing the importance of regular charging to maintain battery life and performance. It is intended for general work light applications, providing versatile lighting options through different brightness settings and a focused beam.

Important Technical Specifications:

Light Source: COB LED (with two brightness settings) and SMD LED (for focus beam).
Battery Type: Sealed lithium battery.
Charging Port: MicroUSB.
Charging Time: Approximately 4 hours to full charge, depending on the initial state of charge.
Storage Temperature: Ideal storage temperature is 70°F (21°C).
Operating Temperature Limit: Do not expose to temperatures above 140°F (60°C).
Charger: AC Wall Charger with USB Port and USB/Micro USB Charging Cord (Part No. LNC215 for replacement kit). Only the provided charger should be used.

Usage Features:

ON/OFF Power Button: Controls the unit's power and cycles through different lighting modes.
COB LED Work Light with 2 Settings: Offers two levels of brightness for the main work light, suitable for various illumination needs.
SMD LED Focus Beam Light: Provides a concentrated beam of light for specific tasks requiring focused illumination.
MicroUSB Charging Port: Standard port for convenient charging.
State of Charge / Charging Status LED Indicator: Blue LEDs blink in succession to show charging progress and remain solid when fully charged.
Magnet: Integrated into the base of a rotating arm, allowing attachment to ferrous metal surfaces for hands-free positioning.
Hook: Incorporated into the unit for hanging, providing additional positioning flexibility.
Rotating Arm: Allows for ideal positioning of the light.
Operational Modes:
1. Press POWER for COB Work Light low brightness mode.
2. Press POWER a second time for COB Work Light high brightness mode.
3. Press POWER a third time for Focus Beam Light mode.
4. Press POWER a fourth time to turn the unit OFF.
Safety Precautions:
- Do not turn on or handle/move the work light while it is being charged.
- Do not look directly into the light or shine it into the eyes of any person or animal.
- Do not allow children to use the work light.
- Do not operate if damaged; take to a qualified service person.
- Always wear eye protection and appropriate protective clothing when working on vehicles or other equipment.
- Use extreme care in engine compartments due to moving parts.
- Read all safety instructions in the vehicle's Owner's Manual if used with a vehicle.

Maintenance Features:

Initial Charge: Charge immediately after purchase.
Regular Charging: Recharge after each use and at least every 3 months when not in use. This is crucial for maintaining the battery's useful life. Failure to perform maintenance charges may greatly reduce battery life.
Battery Discharge: Do not allow the battery to remain in a discharged state for long periods, as this negatively impacts battery life.
Cleaning: After use and before maintenance, disconnect from the charger. Use a dry cloth to wipe any dirt or oil from the charger, cord, and light.
Servicing: Any servicing or repair should be performed by qualified service personnel. Do not disassemble the work light.
Charger Care: Pull by the plug, not the cord, when disconnecting the charger to reduce damage risk. Do not use the charger if the cord or plug is damaged; replace immediately.
Battery Disposal: Recycle or dispose of the used battery as required by local regulations.
Storage: Store inside, in a cool, dry place. Avoid/prevent damage to the charger, cord, and unit during storage. The internal battery will gradually self-discharge over time, especially in warm environments.