SolarEdge Home Battery 48V - Installation Procedure

Installation procedure
1.
Install a floor stand.
Floor stand is optional, however, for durable and robust insulation, SolarEdge
recommends to install the battery modules on top of a floor stand, to be purchased
seperately from SolarEdge. Depending on wall leveling, consider when installing
more than one module.
a.
Place the floor stand at a distance of 3-5cm from the wall.
Figure 4: Floor stand placement
NOTE
The arrow should point at the battery module front.
b.
To level the floor stand, adjust each of the four legs by turning the screw using a
flat screwdriver.
Figure 5: Floor stand leveling
c.
When the floor stand is balanced, tighten the nut with an open wrench in order
to secure the leg's height, then tap it.
Home Battery 48V Installation Guide MAN-01-00954-1.1
16 Installation procedure