Figure 6: Floor stand—tightening the nut
CAUTION!
Before moving the battery module to its location, make sure that both
the CB switch and the power button (soft switch) of the battery module
are off – refer to
Connecting a Single Battery Module
on page 20.
2.
Take the battery module out of the box, move it to the installation location. You can
use the battery handles located at the top of the battery for convenience of moving
and placing it on the the right position.
3.
Place the battery module on the floor stand using the top handles. Make sure that
the battery stands firmly, and not shaky, on the floor stand.
Figure 7: Top handles
Installing the Battery Modules17
Home Battery 48V Installation Guide MAN-01-00954-1.1
To Next Page
Loading...
