4.
Put the bracket on the wall, mark the drilling holes location, then remove the bracket
and drill holes in the wall.
Figure 8: Drilling the holes for the wall bracket
NOTE
Don’t drill through the bracket.
5.
Assemble the supplied mounting bracket to the battery module using two M5
screws. Tighten the screws to a torque of 2.5Nm.
NOTE
For better cable routing, use the mounting bracket oval hole in a way to
enable the maximum available distance between the battery module and the
wall.
Figure 9: Setting the distance from the wall
6.
Secure the battery module to the wall with screws and wall plugs. When using only
two screws, make sure to use the two outer screws diagonally as shown on the
figure below.
Home Battery 48V Installation Guide MAN-01-00954-1.1
18 Installation procedure
To Next Page
Loading...
