3
RS485 Surge Protection Kit Installation Guide - MAN-01-00597-1.0
7. Insert the surge protection board’s connectors into the communication board socket, applying light pressure. Make sure the
connectors are firmly inserted.
Figure 5: Connecting the Surge Protection Device to the Communication Board – View from Above
8. Tighten the screw securing the surge protection device (torque 1.1 N*m/ 0.8 lb*ft), as shown in Figure 4.
9. Connect the 6-pin connector to the surge protection device.
10. Close the inverter cover.
11. Turn ON the AC to the inverter.
12. Turn the Safety Switch (if applicable) to ON.
13. Turn the inverter ON/OFF/P switch to ON.
To Previous Page
Loading...