SolarEdge Solar Inverter - Inverter Status Screens - Operational Mode; Initial Inverter Status

Chapter 5: User Interface
SolarEdge Installation Guide – MAN-01-00057-2.2
36
Information
Select Information to display the following options:
V e r s i o n s
E r r o r L o g
W a r n i n g l o g

Versions: Displays inverter firmware versions :
I D : # # # # # # # # # #
D S P 1 : 0 0 0 1 . 0 2 1 0 . 0 1 8 8
D S P 2 : 0 0 0 1 0 0 3 4 . 0 0 0 0
C P U : 0 0 0 2 . 0 0 3 7 . 0 0 0 0
 ID: The inverter ID.
 DSP 1/2: The DSP digital control board firmware version
 CPU: The communication board firmware version

Error Log: Displays the last five errors.

Warning Log: Displays the last five warnings.
Inverter Status Screens – Operational Mode
Pressing the external LCD light button turns on the LCD backlight. Additional presses display the following
screens one after the other.
Initial Inverter Status
V a c [ v ] V d c [ v ] P a c [ w ]
2 4 0 . 7 3 7 1 . 9 2 3 4 9 . 3
P _ O K : X X X / Y Y Y < S _ O K >
ON

Vac [V]: The AC output voltage.

Vdc [V]: The DC input voltage.

Pac [W]: The AC output power.

P_OK: XXX/YYY: There is a connection to the power optimizers and at least one power optimizer is
sending monitoring data. XXX is the number of power optimizers for which telemetries have been
received in the last two hours. YYY is the number of paired power optimizers identified during the
most recent pairing process. If XXX and YYY are not equal, there may be a problem in one or more
power optimizers.

S_OK: The connection to the SolarEdge monitoring portal is successful (appears only if the inverter is
connected to the server).

ON/OFF: Indicates the position of the inverter ON/OFF switch.
NOTE:
Please have these numbers ready when you contact SolarEdge support.