22
Installation and Wiring
6.2 Installation and Wiring Steps
WARNING!
• Disconnect the AC power supply before electrical connection. Do not work with the
power on, or electric shock may occur.
• All electrical connections must be carried out by qualified personnel in accordance
with legislation in force in the country concerned.
The following descriptions of installation and wiring steps are descibed taking three-phase
EV-Charger as an example.
Step 1: Remove the screw from the EV-Charger with the cross screwdriver. Then remove
the back bracket away carefully.
M4
Figure 6-6 Remove the back bracket away
Step 2: Fix the back bracket and the cable hook (only for Plug Type) to the wall.
a. Use the back bracket as a template to mark the position of the holes on the wall.
45 mm
140 mm
1.3-1.5 m
>400 mm
62 mm
Figure 6-7 Mark the holes
To Next Page
Loading...
