Space Requirement
Ø
Installation Installation
Mounting Steps
Ø
Step 1: Screw the wall bracket on the wall
Tools required for installation.
a) Use the wall bracket as a template to mark the position of the 5 holes on
the wall.
b) Drill holes with driller, make sure the holes are deep enough (at least
50mm) for installation, and then tighten the expansion tubes.
c) Install the expansion pipe in the hole and tighten it.Then attach the
expansion screws to the wall.(Φ 10 drilling machine.Power: 2.5 0.2 Nm)
Installation tools : crimping pliers for binding post and RJ 45, screwdriver,
manual wrench and
Step 2: Install the screw holes on the wall with the screws.
20
21
d) Hang the inverter on the bracket, move the inverter close to the bracket and
gently put down the inverter to ensure that the back plate and wall hanging plate
on the machine are fixed.
300mm
300mm
300mm300mm 500mm
a)
b)
c) d)
Φ 10 drilling machine.Power: 2.5± 0.2
To Next Page
Loading...
