36
Mechanical Installation
Step 2: Set the bracket aside and drill holes with Ø8 drill bit. The depth of the holes
should be 65 mm. Please note that when using a drill, make holes perpendicular
to the wall and avoid tilting up or down.
Figure 7-6 Drilling holes
Step 3: Disassemble the nut, spring washer and flat washer from the expansion sets (part
A). Knock the expansion bolt with tube into the holes.
Spring washer
Flat washer
Nut
Figure 7-7 Disassembling the expansion set
Step 4: Secure the bracket with nut and washers.
Washer (part B)
Flat washer (from part A)
Spring washer (from part A)
Figure 7-8 Securing the bracket
Step 5: Open the anti-static bag, take out the inverter. If the inverter needs to be
temporarily placed on the ground, use foam or other protective materials to
protect it against potential damages. Avoid placing the inverter in a way that the
wiring terminals are in contact with the floor or any other objects as they are not
designed to bear the weight of the inverter.
To Next Page
Loading...
