SolaX Power X3-Hybrid Series - Page 52

Setting
Setting
ShavingStartTime
07:00
DisChgPeriod1
ChargeFromGrid
Disable
Reserved_SOC
50%
ReservedSOC
＞
Peak shaving mode
User Setting
>DisChgPeriod1
DisChgPeriod2
ChargeFromGrid
Reserved_SOC
Peak shaving mode
DisChgPeriod1
DisChgPeriod1
ShavingEndTime
15:00
ShavingLimits1
0W
DisChgPeriod1
>DisChgPeriod2
ChargeFromGrid
Reserved_SOC
Peak shaving mode
DisChgPeriod2
DisChgPeriod2
DisChgPeriod2
ShavingStartTime
19:00
ShavingEndTime
23:00
ShavingLimits2
0W
DisChgPeriod1
DisChgPeriod2
>ChargeFromGrid
Reserved_SOC
Peak shaving mode
ChargeFromGrid
ChargeFromGrid
ChargeFromGrid
ChargePowerLimits
1000W
MAX_SOC
50%
DisChgPeriod1
DisChgPeriod2
ChargeFromGrid
>Reserved_SOC
Peak shaving mode
9 ) Dry Contact
When the user uses the inverter communication control external device
function, you can enter here to set the parameters of the external
response control. For the setting method, please refer to the user manual
of the compatible external device.
If the user uses the inverter dry contacts to control external devices (such
as heat pumps) through the Adapter box, please refer to the Adapter box
quick installation manual to set the parameters here.
10 ) User Password
The default password for the end user is "0000", where you can reset the
new password and press the up/down key to increase or decrease the
value. Press "Enter" to confirm the value and jump to the next digit. When
all passwords have been entered and confirmed, press "OK" to set the
password successfully.
Switch
ON OFF
Load Management
＞ Mode Select
SmartSave
Load Management
Thresholds on
Feedin power
3000W
Load Management
Load Management
Load Management
Minimum duration
per on-signal
5 M
Load Management
Thresholds off
Consumption
500W
Thresholds off
Battery SoC
40%
Minimum duration
per day
900 M
Load Management
＞ Schedule
Enable
Load Management
Work Period 1
Start time
00:00
Load Management
Load Management
Load Management
Load Management
Work Period 1
End time
00:00
Work Period 2
Start time
00:00
Work Period 2
End time
00:00
＞ Mode Select
Disable
Load Management
＞ Mode Select
Manual
Load Management
96
97
0 0 0 0
User Password