17
4 4 2 Installation Mode Requirements. .
Install the inverter upright or at a maximum back tilt of 15 degrees to facilitate heat dissipation.
, . . .Below are some correct / wrong installation modes as shown in Figure 4 8&4 9
Figure 4 8 The correct installation mode.
The correct installation mode
upright back tilt
Figure 4 9 The wrong installation modes.
The wrong installation will lead to failure of the inverter operation.
NOTICE
The wrong installation mode
Horizontally Upside down-
Step 1 Support-mounting the inverter is recommended. Tighten the support and rear panel using
M12 bolt and the required torque is 42N.m as shown in Figure 4 10., .
4 5 Support-mounting the Inverter.
Figure 4 10 Securing a rear panel.
478
230
118
14
To Next Page
Loading...
