To Next PageTo Next Page
Need help?Do you have a question about the Soldo Controls SX Series and is the answer not in the manual?
Details SX and SH boxes for use in hazardous areas with specific gas/vapor/powder groups and temperature classes.
Covers trained personnel, prohibition of user repair, aggressive substances, impact risks, and cleaning advice.
Declares conformity to ATEX directive 94/9/EC and lists applied harmonized standards.
Explains safety alert symbols (Danger, Warning, Caution) and general safety instructions.
Covers mounting bracket attachment, shaft engagement, electrical wiring, and cable entry preparation.
Details procedures for adjusting limit switches and the 3D indicator.
Provides codes and specifications for switch types, cable entries, colors, and other options.
Illustrates wiring for models and the procedure for adjusting cams for switch activation.
Details the ATEX certificate, manufacturer information, and scope of conformity.
Specifies required marking, ambient temperature ranges, and conditions for safe use.
General| Manufacturer | Soldo Controls |
|---|---|
| Ingress Protection | IP67 |
| Electrical Life | 100, 000 cycles |
| Mechanical Life | 1, 000, 000 cycles |
| Series | SX Series |
| Category | Switch |
| Type | Limit Switch |
| Operating Temperature | -25°C to 85°C |
| Contact Configuration | SPDT |
| Operating Temperature Range | -25°C to 85°C |
| Termination Type | Screw Terminal |
| Actuator Type | Roller Lever |
