IMPORTANT TO READ FIRST USAGE RECOMMENDATIONS
• Charge fully before initial use (4 hours).
• Use a DC 5V cord adapter and a computer to charge the headset.
Do not use a DC 9V, DC 12V, DC 24V adapter.
• It is recommended to use a dry towel to clean any sweat or water stains
from the transducers after usage.
• Ensure the charging port is dry when charging after usage.
• Use medium to low volume. Long-term high volume may cause discomfort.
The AO Scan Bluetooth Transducer uses sound vibration to
transmit frequencies and balancing tones played from the various
programs in the AO Scan Software.
BLUETOOTH TRANSDUCER HEADSET
1. Plug in the headset with the
USB Type-C charger. A red-light
LED indicator should appear,
showing it is charging.
2. When charging is complete,
the LED indicator will turn blue.
1. Hold the power button until the device says,
"Power on." The LED indicator will turn on indicating
the device is on.
2. Turn on Bluetooth settings on the device you want
to connect to (Settings app > Bluetooth > Make sure
Bluetooth is on).
3. Under Bluetooth devices, look for the Bluetooth
headset as "AO Scan Mobile" and select it if needed.
4. Once the headset is connected, you will hear "AO
Scan connected" through the transducers.
HOW TO CHARGE HOW TO CONNECT
USER GUIDE
Copyright © 2025 • SOLEX LLC
TM
• All Rights Reserved
To Next Page
General