Need help?Do you have a question about the Solo Golden Tube Audio SE-40 and is the answer not in the manual?
General| Power Output | 40 Watts per channel |
|---|---|
| Signal-to-Noise Ratio (SNR) | 90dB |
| Type | Tube Amplifier |
| Inputs | RCA |
| Output Impedance | 4 ohms, 8 ohms |
| Frequency Response | 20Hz - 20kHz |
| Total Harmonic Distortion (THD) | <1% |
| Amplifier Type | Tube Amplifier |
Details the version history and change control of the manual.
Diagram showing the correct placement of vacuum tubes in the amplifier.
Step-by-step guide for correctly installing the vacuum tubes.
Instructions for connecting audio sources and speakers.
Steps for safely connecting the amplifier to the mains power supply.
How to properly turn on and operate the amplifier.
Explains causes of hum and how to eliminate ground loop noise.
Recommended warm-up and initial usage periods for optimal performance.
Guidelines for continuous operation and recommended break periods.
Instructions for checking and adjusting bias voltage periodically.
Detailed steps for replacing vacuum tubes safely and correctly.
How to configure feedback settings for different tonal characteristics.
Method to increase input gain using different tubes and jumper settings.
Instructions to configure the amplifier for mono or bi-amping setups.
Defines the recommended bias voltage and its importance.
Pre-procedure checks and important notes before biasing.
Lists the necessary tools for performing the bias adjustment procedure.
Information on the original tubes supplied with the SE-40 amplifier.
Common causes and solutions for a completely non-functional audio channel.
To Next Page