55.5Wh
400A
2000A
Discharge Temp. -20℃ ~ 60℃ (-4℉~140℉)
Charge Temp. 5℃~ 45℃ (41℉~113℉)
Approx 2 Hours(PD30W)
This device is equipped with smart energy saving system. It will shut down automatically
once there is no load.
About 1.8-2 hours charged by PD30W AC adaptor.
If the following solution can not solve the problems, please do not use the device again
and contact the seller or manufacturer.
The device can not
turn on when you
press the power
switch.
Do not use it as a car battery.
Do not use it as a car battery charger.
Do not use the device to start the car when it is being charged.
1. Low voltage protection
activated.
2. Over-heating protection
activated.
1. Recharge the device until the
power is above 75%.
2. Let the device cool down for
10 minutes until the temperature
is below 55℃ before the next use.
5V/2.4A,
Green LightSketch
The connection is correct and the
device is ready to start your car.
The device is too hot, please let
the device cool down. /The power
of the device is to low to start the
car./ Please connect the jumper
cables with the device tightly.
Red Light
ON OFF
OFF ON
Blinking OFF
OFF OFF
Reason/Solutions
The power of the car battery
is too low or the car battery is
totally dead. Press "BOOST"
button, the green light will turn
on then start the engine in 30
seconds.
OFF Blinking
Blinking Blinking
Overcurrent protection, please
wait at least 30 seconds until
the next try.
Overheating protection, please
wait 10 minutes until it cool
down.
The connection between the
battery and clamps is reserved.
Please reconnect it correctly
until the green indicator light on.
Red light on with
Buzzing
Model No.: S6 Pro
PD30W
S6 Pro
6.69*3.3*1.22 inch
0.77 lb (350g)
PD 30W
PD 30W
S6 Pro
S6 Pro
S6 Pro
S6 Pro
S6 Pro
S6 Pro
Thank you for choosing SOLVTIN S6 Pro Smart Jump Starter.
Power Switch
LED Screen
Operate following the status of the smart indicator on the
jumper cables.
Go back to your car and start the engine.
USB Output (5V/2.4A)
USB Output (5V/9V/12V QC 3.0)
157铜板折页，单黑正反印刷，90*120mm
Made in China
AC Wall Charger
E. Specification:
Model
Size
Weight
Battery capacity
Output
Input
Recharge time
Starting Current
Peak Current
Discharge Temp.
Charge Temp.
S6 Pro
6.69*3.3*1.22 inch
0.77 lb (350g)
55.5Wh
Type-C PD 30W , USB-A 5V/9V/12V Quick Charge 3.0, 5V/2.4A,
12V Jumper Cable Interface
Type-C PD 30W
Approx 2 Hours(PD30W)
2000A
-200C - (-40F-1400F)
450C (41 OF-1130F)
F. Common questions:
QI : How to turn off the jump starter?
A1 : This device is equipped with smart energy saving system. It will shut down automatically
once there is no load.
Q2: How long does it take to recharge S6 Pro fully?
A2: About 1.8-2 hours charged by PD30W AC adaptor.
Q3: How many times can this S6 Pro charge a phone?
A3: It depends on the battery capacity of the cell phone. Taking iPhone8 as an example it can
charge it for four times.
Q4: How many times can this S6 Pro start a car after a full charge?
A4: Approximately 20 times.
Q5: What's the service life of S6 Pro ?
A5: In regular use, it can work for 2—3years.
Q6: How long can it hold a charge?
A6: The circuit design of S6 Pro is very scientific. It can hold a charge for 6—12 months, but to
extend the service life and be prepared for an emergency, we recommend you to recharge
it fully every three months.
-05-
To Next Page
Loading...