•
A complete User Guide is available online in PDF and usable
formats. Visit www.labstamp.com. For support call
1-800-430-1243 or email at support@somarkinnovations.com
Labstamp System 1.0
QuickStart Guide
L A B S T A M P
TM
By Somark
1 SELECT THE CORRECT RESTRAINT & NEEDLE CARTRIDGE
Step 2 : Pick up a mouse by its tail and place
it on the Restraint Cartridge platform.
Depress the tail grippers on the red dome
cover, position it over the mouse tail, and
release grippers.
Step 3 : Hold the tail across the v-groove,
and starting with the smallest slot on the
left, to the largest slot on the right of the
Tail Gauge, determine the slot that ts the
tail. The t may be snug, but not tight.
Do not use force.
Step 4: Read the Tail Gauge to conrm the correct Restraint
Cartridge (SMALL OR LARGE) is used and to
select the correct Needle Cartridge
(YELLOW or GREEN dot).
2 INSTALL/CHANGE THE NEEDLE CARTRIDGE (50 IDs maximum)
Step 1: With the Applicator Machine
powered ON, press the CHANGE NEEDLE
button.
Step 2: Change the Needle Cartridge by
pressing the forked end of the Tail Gauge
onto the Needle Cartridge. (If no Needle
Cartridge is installed, proceed to Step 3.)
Step 3: Install the appropriate Needle
Cartridge on the gun-head.
3 INSTALL INK SLIDE INTO TAIL COVER (Note: Ink Slides are single-use only.)
Step 1: Clean the Tail Cover bottom of any debris that would prevent the bottom surface from
fully contacting the Restraint Cartridge platform.
Step 2: Insert a new Ink Slide into the Tail Cover, ensuring that the two (2) positioning holes align.
Important Note: The Tail Gauge is to be held vertically and square with respect to the tail. Use the Tail Gauge on each
mouse. Do not rely on age or weight to determine Restraint and Needle Cartridges.
Step 4: Press the CHANGE NEEDLE or
START button to retract the Needle
Cartridge.
Step 1: Make an initial selection of the
Restraint Cartridge (SMALL or LARGE)
based upon whether mice are young
adult, or adult.
To Next Page
Need help?
General
