Caution
1. Be sure to install the device where away from the magnetic wave, vibration, and impact etc.
2. Be sure to connect proper voltage.
3. Do not install the device near the high voltage or radio frequency device which can interfere with
image on the screen.
4. Please install the device on the proper place for electronic devices by avoiding bad effects from
temperature, humidity, sunlight, dust, air etc.
5. As dust on the camera lens can cause unclear image on the screen so please clean the lens
after use.
6. In case of the Lamp door opened, the device does not work for the safety.
Please check the Lamp door status before use.
7. During installation or operation, do not obstruct the entrance of the cooling fan.
8. In case of malfunction, do not disassemble but please contract your supplier or our customer
service dept.
Warning
1. Do not install the device near wet place and avoid water.
(It may cause physical damage by electric shock.)
2. Do not directly stare at the light source with bare eyes.
(It may cause disorder of eyesight after long term disposure.)
To Next Page
Loading...