The picture above is for your reference.
When your garden with different zones, and 2 zones all need to be cutted, pls check the set up process
as below:
1.Between the passage of the 2 lawns, the width of 2 cables should be within 5cm;
2.When robot have finished the work in zone1, you need to choose the manual mode and then put the robot on the
cable inside zone2, then the robot will work ;
3.After finishing work inside zone2, robot will stop on the cable, then you need to manually lift the robot to the dock
station.
4.This set-up procedure could be available for 2 zones, you could follow the steps.
ZONE 2
FP
ZONE 1
To Next Page
Loading...
