remote control will switch off. This may take a
few minutes.
Reading a selected code
If you find the proper code with the quick search
function, it is advisable to note it down to make its
reselection easier. The number of the flashes the
LED makes is equal to the first, second and third
digits of the three-digit number respectively.
Press and hold the SET button and, while doing so,
press a number button (1-2-3) to find out the values
of the various digits. Then release both buttons and
count the flashes.
For example, if the selected code is 261:
1. SET + ”1”: 2 flashes
2. SET + “2”: 6 flashes
3. SET + “3”: 1 flash
note: no flash means zero
Battery replacement
The batteries need to be replaced if the LED
dims out you experience a drop in the range. The
battery compartment cover may be removed
by sliding it in the direction of the arrow. Insert
two AAA 1.5 V batteries according to specified
polarity pattern. It is advisable to use long life
(alkaline) batteries. Rechargeable batteries are not
recommended. Do not mix batteries from
different manufacturers.
Codes selected earlier are retained in the
memory while batteries are being replaced.
Pressing any of the buttons while replacing the
batteries may result in data loss!
Warning
Do not expose the remote control to direct heat,
sunlight, dust, steam or shock.
Remove dust regularly using a soft cloth.
Make sure that no liquid substance is spilt on the
keypad.
Technical data
system: . . . . . . . . . . . . . . pre-programmed, infra red
range: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-7 m
power supply: . . . . . . . . . . . . . . . . . . . 2 x AAA (1,5 V)
dimensions: . . . . . . . . . . . . . . . . . 195 x 65 x 19 mm
4
To Next Page
Loading...
