Sonance Navigator K2 - Cleaning; Keypad Reference

Chapter 2 • Introduction
5
• Do not disassemble the unit. The Navigator K2 contains high voltage circuits
that may cause injury if contacted.
CLEANING
Occasional cleaning may be required, depending on use.
To clean your Navigator K2:
1. Remove the power from the Navigator K2.
2. Lightly dampen a lint-free cloth with water or mild detergent and wipe the
touchscreen, keypad, and outer surfaces.
KEYPAD REFERENCE
KEYPAD SYNC AUX STATUS GND PWR STATUS IR DATA GND +12VDC
Part Number 91975
RS-485 RELAY CTRL
Sonance Navigator K2
Front
Back
Power Off Hard
Button with
Programmable
Power Status
Indicator
Volume and
Channel Hard
Buttons
IR Receiver
Window
Touchscreen
Display
Configurable
Source Hard
Buttons
Removable Connector
for Keypad Power and
Input/Output Functions
RS-485
Network Port
NOTE: The
RS-485 port
is not active
at this time.