Navigator K2 keypad
8
BACKLIGHT LEVEL
This button displays a window that allows you to set the backlight
brightness level of the K2. There are independent settings for the K2’s
Normal operating mode (when it is awake) and the Power Down mode
(when it is asleep). The four brightness choices are High, Medium, Low, and
Off. For the Power Down mode you can also select the Display Off option if
you want the display to show no information while the K2 is asleep. The
High brightness setting is not allowed in the Power Down mode. Press the
OK button in the window to close.
CHANGE PASSCODE
This button displays a window that allows you to set the passcode that is
used to limit access to the Clear All function on the control panel page as
well as the Secured function that is available on all buttons.
When you press the Change Passcode button, the screen will prompt you to
enter the old passcode on the touchscreen followed by the Enter key.
(The default code is 0000).
To Next Page
Loading...
