Navigator K2 keypad
10
CLEAR ALL
This button displays a window that will allow you to erase the current
program in the Navigator K2 keypad. When the button is pressed, you will be
prompted to enter the current passcode. If the proper code is entered, the
entire program in the Navigator K2 will be erased.
Warning! This will erase the complete program in the Navigator K2 with no
way to restore it, except by reloading the program from the Navigator K2
Manager software!
If you inadvertently press the CLEAR ALL button, simply press the ENTER
button without entering the passcode and you will be returned to the
Control Panel page.
Note! All control panel settings are available through the “Edit Device
Properties” window in the edit pull down menu (see chapter 5). Control
panel settings are also reset with every file load so be sure the device
properties are set correctly in each of your files.
To Next Page
Loading...
