Navigator K2 keypad
36
The Button Test step causes the macro to execute the
following steps ONLY IF the button that the macro is attached to is Held Down for
a specified amount of time or Double-Clicked within a specified amount of time,
depending on the option selected.
The Button Test steps are conditional statements or “Else” commands meaning that
if the condition is met the first command will be sent and if the condition is not met
the second command will be sent.
Held Down - In the example above, if the button is held down for 0.3 seconds, the
ON command will execute. If the button is not held down for 0.3 seconds, the
command will not execute.
This can be used to make a source button that switches pages if pressed briefly, or
switches pages and turns equipment on if held down for the specified amount of
time. This can also be used to send a command when pressed briefly, or send a
different command when held down.
Double-Clicked – In the example above, if the button is double-clicked within 0.3
seconds, the ON command will execute. If the button is not double-clicked within
0.3 seconds, the command will not execute.
This can be used to make a source button that switches pages if pressed once, or
switches pages and turns equipment on if double-clicked within the specified
amount of time. This can also be used to send a command when pressed once or
send a different command when double-clicked.
To Next Page
Loading...
