6
English
3
Hold the top of the handle with one hand and
strike the handle housing 0.5 inch above the
bottom end. Strike firmly with a hammer on all 4
sides to eject the end cap.
Note: You may have to hit on the end several times
to break the internal snap connections.
4
Remove the end cap from the toothbrush handle.
If the end cap does not release easily from the
housing, repeat step 3 until the end cap is
released.
5
Holding the handle upside down, press the shaft
down on a hard surface. If the internal components
do not easily release from the housing, repeat step
3 until the internal components are released.
6
Pull the internal assembly to detach it from the
housing tube.
7
Insert the screwdriver between the bottom of the
battery and the frame to break the metal tab
connecting the battery to the printed circuit board.
8
Grab the battery and pull it away from the internal
components to break the second metal battery
tab.
Caution: Be aware of the sharp edges of the
battery tabs so as to avoid injury to your fingers.
9
Cover the battery contacts with tape to prevent
any electrical short from residual battery charge.
10
The rechargeable battery can now be recycled and
the rest of the product discarded appropriately.
To Next Page
Loading...
