Need help?Do you have a question about the Sonicware LIVEN XFM and is the answer not in the manual?
General| Brand | Sonicware |
|---|---|
| Model | LIVEN XFM |
| Category | Recording Equipment |
| Language | English |
Instructions for connecting power and inserting batteries for initial use.
Steps to turn on the LIVEN XFM unit.
Selecting and switching between the four available synth engines.
Fine-tuning parameters for the selected synthesizer engine.
Selecting one of ten filter types for sound shaping.
Selecting one of eight LFO (Low Frequency Oscillator) shapes.
Transposing the pitch of a track in semitone increments.
Selecting the voice allocation mode (Poly, Mono, Legato, Arp).
Selecting one of twelve arpeggiator patterns.
Storing patterns to memory for later recall.
Selecting one of twelve available insert and send effects.
Syncing the LIVEN XFM's tempo with external gear via SYNC IN.
Specific instructions for syncing with ELZ_1 or Pocket Operator.
Recording notes and parameters step-by-step.
Recording sequences by playing the keyboard in real time.
Recording parameter changes that occur at specific steps.
Recording sound changes that occur at specific steps.
Entering sound editing mode to adjust parameters.
Recording sounds from specific synth engines for saving.
Choosing which operator within a sound to edit.
Adjusting signal flow and feedback between operators.
Defining the frequency ratio for each operator.
Setting an operator's frequency to a fixed value.
Adjusting the output level of individual operators.
Setting the specific frequency value for an operator in fixed mode.
Applying fine detuning to an operator's pitch.
Shaping the amplitude or frequency envelope of an operator.
Defining the shape of the operator's envelope (ADSR).
Enabling or disabling the pitch envelope for an operator.
Configuring the pitch envelope's level and time parameters.
Adjusting how keyboard velocity affects operator depth.
Defining velocity response curves for operator depth.
Setting the position for keyboard gain scaling.
Adjusting how keyboard velocity influences operator levels.
Adjusting how keyboard velocity affects time-based parameters.
Setting the signal levels from operators to the mixer.
Adjusting the final output level from the mixer.
Choosing FM algorithm structures and operator routing.
Adjusting voice modes while in sound editing.
Resetting all settings to their factory defaults.
Procedure for updating the unit's firmware.
To Next Page
