Interchangeable Lens Digital Camera
ILCE-6000
Capturing a basic white color in [Custom Setup] mode
In a scene where the ambient light consists of multiple types of light sources, it is recommended to use the custom white
balance in order to accurately reproduce the whiteness.
1. MENU → (Camera Settings) → [White Balance] → [Custom Setup].
2. Hold the product so that the white area fully covers the AF area located in the center, and then press on the
center of the control wheel.
The calibrated values (Color Temperature and Color Filter) are displayed and registered.
Note
The message [Custom WB Error] indicates that the value is higher than the expected range, when the flash is used
on a subject with too bright colors in the frame. If you register this value, the indicator turns yellow on the
recording information display. You can shoot at this point, but it is recommended that you set the white balance again
to get a more accurate white balance value.
Notes on use
4-534-933-11(1)
Copyright 2014 Sony Corporation
Help Guide
How to Use
To Next Page
Loading...
