Sony BRAVIA XR-65A95K

− 14 (US) −
Installing the Wall-Mount
Bracket to the Wall
1 Decide on the installation
location.
Make sure that the wall has enough space
for the TV and is capable of supporting a
weight of at least six times that of the TV.
• Refer “Measurement for Wall-Mount
Bracket installation on the wall” on page
23.
• Refer to your TV’s Reference Guide for the
TV’s weight.
Note

When your TV is installed on the wall, the upper
side of the TV slightly leans forward.

We recommend you to check the position of TV in
the viewing environment.
2 Align
WM1
to the wall and make
four marks.
× 4
WM1
Note

Use a level to check whether
WM1
is level.
3 Drill pilot holes on the marks.
Make sure the location on the wall to drill
the holes are strong enough to support a
weight of at least six times that of the TV.
× 4
75mm
(3inch)
10mm
(13/32inch)
Note

Pilot holes must be drilled to a depth of 75mm
(3inch), using a 10mm (13/32inch) diameter drill
bit.
4
WA1
5 Install
WM1
on the wall.
WS2
WW1
WM1
Note

Use a level to check whether
WM1
is level.
Precaution

Do not over-tighten the lag bolts
WS2
. Improper
tightening could reduce the holding power of the
lag bolts
WS2
.