CDX-G1200U/G1201U/G1202U/G1280UM
10
Make sure your car’s auxiliary power
connector, and match the connections of
cords correctly depending on the car.
Power connection diagram
Auxiliary power connector
Common connection
When the positions of the red and
yellow leads are inverted
When the car without ACC position
After matching the connections and
switching power supply leads correctly,
connect the unit to the car’s power supply. If
you have any questions and problems
connecting your unit that are not covered in
this manual, consult the car dealer.
12
continuous power
supply
Yellow
15 switched power supply Red
12 switched power supply Yellow
15
continuous power
supply
Red
Installation
Before installing the unit, remove the
protection collar and the bracket ʓ from
the unit.
1 Pinch both edges of the protection
collar , then pull it out.
2 Insert both release keys until they
click, and pull down the bracket ʓ,
then pull up the unit to separate.
Removing the protection collar
and the bracket
ʓ
Face the hook inwards.
Before installing, make sure the catches on
both sides of the bracket ʓ are bent
inwards 2 mm (
3
/32 in).
1 Position the bracket ʓ inside the
dashboard, then bend the claws
outward for a tight fit.
2 Mount the unit onto the bracket ʓ,
then attach the protection collar .
Notes
• If the catches are straight or bent outwards, the
unit will not be installed securely and may spring
out.
• Make sure the 4 catches on the protection collar
are properly engaged in the slots of the unit.
Mounting the unit in the
dashboard
ʓ
182 mm (7
1
/4 in)
53 mm (2
1
/8 in)
Catch
When replacing the fuse,
be sure to use one
matching the amperage
rating stated on the
original fuse. If the fuse
blows, check the power
connection and replace the
fuse. If the fuse blows again after
replacement, there may be an internal
malfunction. In such a case, consult your
nearest Sony dealer.
Fuse replacement
To Next Page
Loading...
