CDX-G1200U/G1201U/G1202U/G1280UM
27
Pin No. Pin Name I/O Description
66, 67 DEBUG_6, DEBUG_7 O Debug test terminal Not used
68 BEEP O Beep sound output to the power amplifi er
69 REMOTE_10K O Pull-up resistor (10K) selection signal output terminal (for rotary commander) Not used
70 REMOTE_1K O Pull-up resistor (1K) selection signal output terminal (for steering control)
71 RE_ON O Jog dial pulse pull-up signal output terminal
72 RE_IN1
I Jog dial pulse signal input from the rotary encoder (B phase input)
73 RE_IN0 I Jog dial pulse signal input from the rotary encoder (A phase input)
74 to 77 NC - Not used
78, 79 KEY_1, KEY_0 I Front panel key input terminal
80 RC_IN0 I Rotary commander key input terminal
81 RC_IN1 I Rotary commander shift key input terminal
82 MECHA_ON I
Power detection signal input terminal for CD mechanism section
“H”: CD mechanism power on
83 NC O Not used
84 EN_USB O USB power on/off control signal output to the VBUS switch “H”: power on
85 VSS4 - Ground terminal
86 VDD4 - Power supply terminal (+3.3V)
87 to 89 NC O Not used
90 PANEL_DET
I Front panel detach/attach detection signal input terminal “L”: front panel is attached
91, 92 NC O Not used
93 MEC_DSW
I Chucking end detection switch input from the CD mechanism deck block
94 MEC_LSW I Limit in detection switch input from the CD mechanism deck block
95 FILT I Filter terminal for PLL
96 MEC_LOAD O
Loading motor drive signal (loading direction) output to the CD mechanism deck block
“H”: motor on
97 MEC_INSW
I Disc insert detection switch input from the CD mechanism deck block
98 MEC_SELFSW
I Self loading position detection switch input from the CD mechanism deck block
99 DRV_ON O Driver control signal output to the CD mechanism deck block
100 MEC_EJECT O
Loading motor drive signal (eject direction) output to the CD mechanism deck block
“H”: motor on
To Next Page
Loading...
