14
CDX-L380X
Pin No. Pin Name I/O Pin Description
52 RFOK I CD RFOK signal input
53 CD_RST O CD reset signal output
54 A0 O CD command/parameter signal output
55 STB O CD strobe signal output
56 X_EN O CD crystal oscillator control output
57 LIMIT I CD limit switch input
58 PH1 I Not used. (Fixed at H in this set)
59 D_SW I CD down switch input
60 INSW I CD disc in switch input
61 NC (PH3) — Not used. (Fixed at H in this set)
62 CD_LM_LO O Loading motor control output (Loading direction)
63 CD_LM_EJ O Loading motor control output (Eject direction)
64 NC — Not used. (Open)
65 NC — Not used. (Open)
66 AMPATT O Power amplifier attenuator control output
67 AMPON O Power amplifier standby control output
68 CDMD_ON O CD mechanism power control output
69 ATT O System attenuate control output
70 VOLATT O Electronic volume attenuate control output
71 NC — Not used. (Open)
72 NC — Not used. (Open)
73 NC — Not used. (Open)
74 NC — Not used. (Open)
75 NC — Not used. (Open)
76 NC — Not used. (Connect to ground in this set)
77 NC — Not used. (Connect to ground in this set)
78 DIMSEL — Not used. (Open)
79 XCD_ON O CD power control output
80 TU-ATT — Not used. (Open)
81 NC — Not used. (Open)
82 NC — Not used. (Open)
83 NC — Not used. (Open)
84 NC — Not used. (Open)
85 NC — Not used. (Open)
86 E2P_SIO I/O EEPROM serial data input/output
87 E2P_CKO O EEPROM serial clock output
88 NC — Not used. (Open)
89 FLASH_W I Flash write input
90 NS_MASK O Noise detection output
91 AD_ON O Key power control output
92 NC — Not used. (Open)
93 ILLON O Illumination power control output
94 DOORSW I Not used. (Connect to ground in this set)
95 DAVSS — Ground for D/A converter.
96 NC — Not used. (Open)
97 NC — Not used. (Open)
98 RCIN1 I Rotary commander input 1 (Fixed at L in this set)
99 RAMBU — Not used. (Connect to ground in this set)
100 DAVDD — D/A converter power supply pin (+5 V)
To Next Page
Loading...
