— 9 —
SECTION 4
DIAL POINTER INSTALLATION
Note : Follow the installation procedure in the numerical order given.
1 Align the pointer with the groove of front cabinet assy and insert it as shown in the illustration.
2 Align Knob (TU) with front cabinet and fasten the screw.
3 Turn the Knob (TU) in the direction of the arrow as shown in the illustration until pointer agrees with scale “ 0 ” (at leftmost end of
scale).
4 Turn the tuning capacitor gear fully in the direction of the arrow as shown in the illustration.
5 Fasten the front cabinet assy and rear cabinet assy with the screws.
2
Screw
+BVTP 2.6
×
8
1
Pointe
To Next Page
Loading...
