WARNING
To
reduce
the risk offire or
electric
shock,
do
not expose
this apparatus to rain or
moisture.
CAUTION
The use
of
optical instruments with this
product
will
increase eye hazard.
Notice
for
the
customers in
the
U.S.A
CAlJTION: TO REDUCE THE RISK
OF
ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER·SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Lh
This symbol is intended to
alert the user to the presence
of
uninsulated "dangerous
~
voltage"
within the product's
enclosure that may be
of
sufficient magnitude to
constitute a risk
of
electric
shock to persons.
~
This symbol
is
intended to
I
alert the user
to
the presence
of
important operating
and
• maintenance (servicing)
instructions in the literature
accompanying the appliance.
Note
to
CATV system installer:
This reminder
is
provided to call the
CATV system installer's attention to·
Article 820-40
of
the NEC that provides
guidelines for proper grounding and, in
particular, specifies that the cable ground
shall be connected to the grounding
system
of
the building,
as
close to the point
of
cable entry as practical.
The following
FCC
statement
.pplle.
only
to
the
ver.lon
of
thl.
model
manufactured
for
sale In
the
U.S.A.
Other versions
may
not
comply
with
FCC
technical regulations.
WARNING
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part
15
of
the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and,
if
not installed
and
used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference
will
not occur in a particular installation.
If
this equipment does cause harmful
interference to radio
or
television
reception, which can be determined
by turning the equipment off
and
on,
the user
is
encouraged to
try
to
correct
the interference by one
or
more
of
the
following measures:
- Reorient
or
relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet
on a circuit different from that to which
the receiver
is
connected~
- Consult the dealer
or
an experienced
radio/TV technician for help.
CAUTION
You
are cautioned that any changes
or
modifications not expressly approved in
this manual could void your authority to
operate this equipment.
This equipment must not be co-located
or
operated in conjunction with any other
antenna
or
transmitter.